Published Sep 1. 2015 - 8 years ago

Bunny Split

Articles w/pattern

Originator: 
Mark Dysinger
Pattern type: 
Pike fly
Skill level/difficulty: 
Easy
Instruction: 
  1. Fasten the hook in the vise and start the thread about one third of the hook shank behind the eye. Bend a short piece of wire to form a loop, and secure the loop to the top of the hook shank towards the bend with a series of thread wraps. Place a smooth layer of flexcement or equivalent on the wraps that secure the loop guard.
  2. Prepare a magnum zonker strip that is twice the length of the hook shank by tapering the end to a point in the hide. Place the strip hide side up on the shank and about one third of the shank back from the hook eye. Secure the strip with a series of tight thread wraps, and finish with the thread back near the hook bend. Place a smooth layer of flexcement or equivalent over the wraps that hold the zonker strip to the hook.
  3. Tie in about a dozen strands of Krystal Flash on top of the zonker strip. Keep them long so that the ends of the strands extend a bit past the end of the zonker strip.
  4. Prepare a second magnum zonker strip as previously done in step 2. Tie this one hide side down on top of the Krystal Flash so that its length is identical to that of the lower zonker strip. Secure it as previously described in step 2.
  5. Start layering the marabou collar by tying in four bunches of marabou: one on top of the hook shank, one underneath, and one on each side. Tie them in at the farthest thread wrap back that holds the tail components in place, and put each subsequent layer a bit farther front than the previous. This method will not give a perfectly rounded collar at each individual layer, but as each layer is added any gaps will eventually be filled. The collar is complete after four layers are tied in.
  6. To complete the fly, build up thread ahead of the collar and add eyes. Lightly coat the head area with 5 minute epoxy. Use the epoxy to taper the head as necessary.
Materials: 
Hook
Dai-Riki #810 or equivalent, 3/0
Thread
3/0
Tail guard
Wire loop
Lower tail
Magnum zonker strip
Tail flash
Krystal Flash
Upper tail
Magnum zonker strip
Collar
Three layers of marabou
Eyes
Doll eyes
Head
5 minute epoxy

Log in or register to pre-fill name on comments, add videos, user pictures and more.
Read more about why you should register.